Removal and Installation Procedures
6-16
3.
Pull the shaft out of the knob to separate the two pieces.
Installing Front-Panel Knobs and Shafts
1.
Align the inside of the knob to the end of the shaft and push it
in
until it
snaps.
2.
Insert the shaft
of
the assembly into the proper hole
on
the front panel
and push it
in
until it stops.
3.
Lightly push
in
the knob and rotate it until the shaft slips into place.
4.
Push the knob all the way
in
to seat the assembly.
Figure 6-6: Knob and Shaft Removal
Maintenance
•
•
•
To Next Page
Loading...
