Tektronix TekScope THS710A User Manual

Preface
vi
THS710A, THS720A, THS730A & THS720P User Manual
Conventions
TekScope instrument setups are shown in tables. The Operaing
Basics and Performance Verification sections use tables to show
specific setups. The Reference section uses similar tables to show the
complete contents of the menu system.
The header of each table contains icons that represent the controls
and menu items used to set up the instrument. To make a specific
setup, read the table from left to right and then from top to bottom as
shown below. The table contains the symbol “—” if no action is
required.
1. Choose
scope mode
or meter
mode.
2. Press this
button on the
front panel.
3. Press this
bezel button.
4. Press the
bezel button
again until
this selection
is highlighted.
5. Use the
+
/– rocker to
set the value
for a parame-
ter.
6. 7. —
8. 9. 10.

Tektronix TekScope THS710A Specifications

General

Brand	Tektronix
Model	TekScope THS710A
Category	Test Equipment
Language	English