UTILITY
3–62
THS710A, THS720A, THS730A & THS720P User Manual
UTILITY
The following are examples of what you can do with each of the six
branches in the Utility menu:
H Use Config to display the firmware version.
H Use Hard Copy to set up hard copy parameters. Refer to HARD
COPY on page 3–22 for information about setting up and printing
a hard copy.
H Use RS-232 to set up for remote communication.
H Use Misc to set the standby or backlight timeout.
H Use Cal to compensate the signal path.
H Use Diag to run internal diagnostic routines.
Press the UTILITY button to display the utility menu. You can
access the same utility menu from scope mode or meter mode. Then,
use the left-most button in the utility menu to choose the branch. The
remaining items in the utility menu may change depending on the
branch you choose.
To Next Page
Loading...
