THS710A, THS720A, THS730A & THS720P User Manual
D–1
Appendix D: Performance Verification
This appendix contains performance verification procedures for the
specifications marked with the n symbol. The following equipment,
or a suitable equivalent, is required to complete these procedures.
Description
Minimum
Requirements
Examples
DC Voltage Source 60 mV to 800 V, ±0.1%
accuracy
av
t
k
1
niv
al
Calibration System with
AC Voltage Source 300 mV to 640 V, ±0.5%
accuracy at 500 Hz
cillo
cop
ali
ation
Module (Option 250)
Resistance Standard
360 to 36 M, ±0.1%
accuracy
luk
55
Multi-
product Calibrator with
cillo
cop
ali
ation
Leveled Sine Wave Gen-
erator
50 kHz to 200 MHz,
±3% amplitude accuracy
Option (Option
5500A-SC)
Time Mark Generator 10 ms period, ±50 ppm
accuracy
Banana to Banana
Cable (two required)
Shielded banana jacks
on each end
Tektronix Deluxe Meter
Lead Set (ATLDX1)
50 BNC Cable
BNC male to BNC male,
≈ 36 in (1 m) long
Tektronix part number
012-0482-XX
50 Feedthrough Ter-
mination
BNC male and female
connectors
Tektronix part number
011-0049-XX
Dual Banana to BNC
Adapter
Banana plugs to BNC
female
Tektronix part number
103-0090-XX