Getting Started
THS710A, THS720A, THS730A & THS720P User Manual
1–9
Functional Check
After you install batteries or connect external power, you can
perform this quick functional check to verify that your TekScope
instrument is operating correctly.
1. Press the ON/STBY button to turn on the TekScope instrument.
2. After a few seconds, you should see a window with the message
Power-On self check PASSED. Press the CLEAR MENU button.
3. Press the SCOPE button.
4. Connect the oscilloscope probe to the channel 1 input BNC.
Attach the probe tip and reference lead to the PROBE COMP
connectors on the right side of the TekScope instrument.
Probe tip to PROBE COMP
Probe reference lead to
Ch 1
To Next Page
Loading...
