Tektronix TekScope THS710A

AUTORANGE
THS710A, THS720A, THS730A & THS720P User Manual
3–9
These conditions start an autorange cycle.
Scope Mode Meter Mode
Too many or too few waveform
periods for a clear display of the
lower-numbered channel
D
MM
re
a
d
ing
e
xc
eeds
±3
600
count
s
or falls below ±330 counts
Waveform amplitude too large or too
small compared to full screen if only
one channel is displayed
Waveform amplitude too large or too
small compared to half screen if two
channels are displayed
Autorange adjusts these controls.
Scope Mode Meter Mode
Vertical VOLTS/DIV adjusted
R
ang
e
a
d
ju
s
t
ed
(to 4 V o
r
high
er
res
Horizontal SEC/DIV adjusted
r
ang
es
only)
Trigger level set to 50%