CURSOR
3–12
THS710A, THS720A, THS730A & THS720P User Manual
Measuring Phase. Move the V Bar cursors to the 0 ° and 360 ° points
and then press the Set 0° and 360° with V Bars button. Next, move
either cursor to the point you want to measure.
Horizontal Bar cursors
Vertical Bar cursors
Paired cursors
D 4.16 V
@ –1.78 V
D 6.12 ms
@ 1.06 ms
D 6.32 V
D 5.86 ms
@ 3.16 V
@ Readout. For V Bar cursors, the readout after the @ symbol
indicates the location of the active cursor relative to the trigger point.
For degrees measurements, the readout is relative to the 0_ and 360_
points that you set. For H Bars or Paired cursors, it indicates the
location relative to zero volts.
To Next Page
Loading...
