Aligna
®
4D User Manual
37 / 84
Set detector sensitivity (PSD Gain parameters) (already done if you got the Plug'nPlay
Kit)
Switch on the regulator
Stabilization should work immediately, if the setup is similar to the setup used for setting the
default parameters at TEM Messtechnik GmbH before delivery, or if you use the delivered
Plug'n Play Kit.
If the setup is different, it will probably be necessary to modify some parameters:
Alignment of the OCLM Matrix (for Motorized Mirror Mounts) by automatic learning (or
by manual setting)
If you have additional piezo actuators:
Alignment of the OCL Matrix (for Piezo Actuators) by automatic learning (or by manual
setting)
Optimizing the servo parameters
These steps will we described now in more detail:
To Next Page
Loading...