TEM Aligna 4D - Page 4

Aligna
®
4D User Manual
4 / 84
6.1 Repetition Rate Categories ........................................................................ 32
6.1.1 CW Lasers ........................................................................................................ 32
6.1.2 CW Lasers with Intensity modulation (5 kHz to 200 kHz) .................................. 33
6.1.3 Pulsed Lasers with Slow Repetition Rates (1 Hz … 3 kHz) ............................... 33
6.1.4 Pulsed Lasers with medium repetition rates (3 kHz … 15 kHz) ......................... 33
6.1.5 Pulsed Lasers with high repetition rates (>15 kHz … > 1 GHz) ......................... 34
7 Input CrossLink Matrix (ICL) .......................................................................... 35
8 Output CrossLink Matrix (OCL) ...................................................................... 35
9 Setting up an Aligna
®
Test System ................................................................ 36
9.1.1 Cable Connections: ........................................................................................... 38
10 Setting up the Aligna
®
System by Help of Kangoo ....................................... 41
10.1 Some basic Kangoo features ..................................................................... 41
10.1.1 Installation of Kangoo ........................................................................................ 41
10.1.2 Buttons and Devices ......................................................................................... 41
10.1.3 Sections ............................................................................................................ 42
10.1.4 Hotkeys ............................................................................................................. 42
10.1.5 Further Kangoo Functions ................................................................................. 43
10.2 Main Aligna
®
Configurations ....................................................................... 44
10.2.1 Configuration "Aligna User Menu" ("BL Menu") ................................................. 44
10.2.2 Configuration "BeamLock Basic" ....................................................................... 45
10.3 Some Common Sections ............................................................................ 47
10.3.1 PSD Input Section ............................................................................................. 47
10.3.2 PSD Input Section ............................................................................................. 48
10.3.3 "Physical Units" Section .................................................................................... 51
10.3.4 "Calibration" Section .......................................................................................... 51
10.3.5 "3D Beam" Section ............................................................................................ 52
10.3.6 "3D Beam" Section ............................................................................................ 53
10.3.7 "Thresholds" Section ......................................................................................... 53
10.3.8 "Hidden Parameters" Section ............................................................................ 54
10.3.9 "OCLM" (Motors Output Crosslink Matrix) Section............................................. 55
10.3.10 Alignment of the "OCLM" Matrix (Output CrossLink Matrix of Motorized
Actuators) 57
10.3.11 Alignment of the Piezo OCL Matrix OCLP (Piezo’s Output Crosslink Matrix) . 65
10.4 Storing and Recall of the Individual Parameters......................................... 68
10.4.1 Recall of the (User-Specific) Default Parameters .............................................. 68
10.4.2 Storing the actually defined Parameters as Default Parameters (into the µC's
FlashEEPROM) ............................................................................................................... 68
10.4.3 Defining the Hardware-Specific Parameters ...................................................... 69