To access the configuration page, log in to the web UI of the Mesh device, and choose More >
Advanced > Static Routing.
The following table describes the parameters displayed on this page.
Parameter description
Specifies the IP address of the destination network.
If Destination Network and Subnet Mask are both 0.0.0.0, this is the default route.
When no route of packets can be found under Routing Table, the Mesh device will
forward the packets using the default route.
Specifies the subnet mask of the destination network.
Specifies the ingress IP address of the next hop router after the data packet exits
from the interface of the Mesh device.
0.0.0.0 indicates that the destination network is directly connected to the Mesh
device.
Specifies the interface that the packet exits from.
The available options include:
: Used to modify a static routing rule.
: Used to delete a static routing rule.
To Next Page
Loading...
