An example of adding a static routing rule
Scenario: You have a Mesh device and another two routers. Router1 is connected to the internet
and its DHCP server is enabled. Router2 is connected to an intranet and its DHCP server is disabled.
Goal: You can access both the internet and intranet at the same time.
Solution: You can configure the static routing function to reach the goal.
Assume the LAN IP addresses of these devices are:
−
Mesh device: 192.168.0.1
−
Router1: 192.168.10.10
−
Router2: 192.168.10.20
Information about the intranet:
−
IP address: 172.16.105.0
−
Subnet mask: 255.255.255.0
Configuration procedure:
Step 1
Log in to the web UI.
Step 2
Refer to Access the internet through a dynamic IP address to configure the internet access
for the Mesh device.
To Next Page
Loading...
