Step 3
Add a static routing rule on the Mesh device.
1.
Choose More > Advanced > Static Routing.
2.
Click Add.
3.
Enter the IP address of the destination network, which is 172.16.105.0 in this
example.
4.
Enter the subnet mask of the destination network, which is 255.255.255.0 in this
example.
5.
Enter the ingress IP address of the next hop router, which is 192.168.10.20 in this
example.
6.
Click OK.
The new static routing rule is displayed under Routing Table.
---End
After completing the configuration, you can access both the internet and intranet through the
Mesh device at the same time.
To Next Page
Loading...
