4.
Enter the user name and password, which are JohnDoe and JohnDoe123456 in this
example.
5.
Click Save.
Wait until Connected is displayed after Connection Status, which indicates that the
configuration is successful.
Step 3
Configure the port mapping function by following the steps in Port mapping.
---End
When completing the configuration, users from the internet can access the FTP server by visiting
“Intranet service application layer protocol name://Domain name”. If the WAN port number is not
the same as the default intranet service port number, the visiting address should be: “Intranet
service application layer protocol name://Domain name:WAN port number”. In this example, the
address is ftp://o2849z7222.zicp.vip.
To Next Page
Loading...
