Used to turn on/off the LED indicator of the secondary node.
You can use this function to check which device you are operating. Turn on/off all
indicators prevails to this operation.
Add a node
−
The node to be added must support the EasyMesh or Xmesh protocol.
−
The node to be added must be located within the signal coverage of the primary node.
−
A maximum of nine nodes can be added to a Mesh network.
Step 1
Log in to the web UI (mobile client).
Step 2
Tap Network Topology and then Add Node.
Step 3
Follow the instructions displayed.
If the LED indicator of new node lights solid on and the new node is displayed in Network
Topology, the node is added successfully.
---End
To Next Page
Loading...
