---End
The following table describes the information and operation shortcuts displayed under Node Info.
Indicates the name of a secondary node, which is Agent by default. You can change
the name by clicking .
Indicates the IP address of a secondary node.
Indicates the MAC address of a secondary node.
Indicates the network connection time of the secondary node and the networking
mode, such as Wired, 2.4G and 5G.
Shows the connection signal strength with the primary node. You can hover your
mouse over to see the strength value.
Provides a button for turning on/off the LED indicator of the secondary
node. You can use this function to check which device you are operating. Turn on/off
all indicators prevails to this operation.
The available options include:
: Used to reboot the node.
: Used to remove the node. Removing a node will narrow the Wi-Fi coverage,
and the removed node will no longer join the current network automatically. To add a
removed node again, go to Add a node.
Add a node
−
The node to be added must support the EasyMesh or Xmesh protocol.
−
The node to be added must be located within the signal coverage of the primary node.
−
A maximum of nine nodes can be added to a Mesh network.
To add a node:
Step 1
Log in to the web UI.
To Next Page
Loading...
