The following message is displayed, indicating that the settings are saved successfully.
---End
Verification:
You can ping an IPv6 website (240c::6666 for example) to check whether the Mesh device accesses
the IPv6 network successfully. The following steps are for your reference.
Step 1
On a computer connected to the Mesh device, press Windows + R to open the Run dialog
box.
Step 2
Type cmd and then click OK to open a regular Command Prompt.
Step 3
Enter ping 240c::6666 and press Enter.
---End
As shown in the following figure, if the number of packets received is not 0, the Mesh device
accesses the IPv6 network successfully.
If the IPv6 network fails, try the following solutions:
−
Ensure that you have entered the correct WAN IPv6 address.
−
Ensure that clients connected to the Mesh device obtain their IPv6 address through
DHCPv6.
−
Consult your ISP for help.
To Next Page
Loading...
