INTRODUCTION
1A-4
SERIAL NUMBERS
See Figure 1A-2 for location of tractor assembly series
number.
Figure 1A-2. Serial Number Location
GENERAL CLEANING
Improper cleaning and lubrication of your machine
results in equipment failures. Before any repairs are
undertaken, thoroughly clean the exterior of the com-
ponent to be removed.
Use a clean surface to lay out parts being removed.
Keep lubricants clean and cover containers not being
used. Plug or cap all hydraulic lines and ports to
hydraulic components immediately after disconnecting.
SAFETY
Safety should always be the rule when working on or
with machinery. Always use safe practices and com-
mon sense when using hand or power tools. Use the
suggested procedures in this manual when working
with the tractor.
Throughout this manual signal words will be used to
highlight special procedures. The signal words and
their meanings are as follows:
NOTE:
Any task needing special care when performing a
procedure.
Decals on the machine denote cautions, warnings, and
dangers. These cautions, warnings, and danger decals
must be on the machine at all times. If they become
worn, torn, or painted over, new decals should be
installed as shown in Section 14A of this manual.
Serial No. Plate On
Left Side of Frame
CAUTION
Hazards or unsafe practices which could result in
personal injury, or product or property damage.
WARNING
Hazards or unsafe practices which could result in
severe personal injury or death.
DANGER
Imminent hazards which will result in severe per-
sonal injury or death if precautions are not taken.
CAUTION
Disconnect leads at the alternator before electric
welding is done on components in common ground
with the engine.
DANGER
This machine is equipped with an interlock system
which is intended to protect the operator and other
from injury, by preventing the engine from starting,
unless the reel switch is in the “Off” position, traction
pedal is in the “Neutral” position and the brake is set.
The system also shuts off the engine if the operator
leaves the seat with the reel switch in “Cut” position.
In the interest of safe operating conditions, this
machine must never be operated with the interlock
relays or interlock system disconnected or malfunc-
tioning.
To Next Page
Loading...
Need help?
General
