Tomey UD-8000 - Entering Calculation Parameters

■ 3-142
3.7.2 Entering calculation parameters
a) Axial length and ACD
When a measurement is completed, the axial length and the ACD are
already entered automatically and cannot be entered manually. (Refer to
“3.5.3 b) Selecting specific axial length data to be used in calculating IOL
power.”) When measurement has not yet been performed, enter the data as
follows.
1) Touch the axial length input field (1) or the ACD input field (2) to activate it.
The keypad (3) appears.
2) Enter the data using the keypad (3), and touch the “Enter” key (4) to reflect
it.
[Acceptable range]
Axial length: 13.00 - 45.00 mm
ACD: 0.00 - 10.00 mm
(Fig. 1)
(1) (2)
(3)
(4)
3-100