■
3-20
3.2.2 Wireless communication connection with AL-4000 measuring unit
■
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
a) Wireless communication setting
Refer to “3.12.2 g) Wireless Communication Setting” to make settings.
b) Connection for wireless communication
■
Check that both or either of connected devices is in
new patient mode before starting to communicate the
patient information and measurement data.
Communication cannot be started while both devices
maintain the information and measurement data of the
last patient.
To Next Page
Loading...
Need help?
General
