3-21
■
■
When connecting a device with a USB cable during
wireless communicating, wireless connection is
changed to wired connection.
[Automatic connection upon startup]
When the AL-4000 is selected as the “connection place” in this instrument,
wireless communication automatically starts when both the AL-4000 and this
instrument are turned on. However, if the AL-4000 has already started wireless
communication with another device, this instrument cannot start wireless
communication. Refer to “3.12.2 g) Wireless Communication Setting” for how to
set “automatic connection upon startup.” Refer to the instruction manual of an
AL-4000 measuring unit for how to set the AL-4000 measuring unit.
[No communication state]
■
The confirmation screen appears when the data
between the AL-4000 and this instrument does not
match.
The confirmation screen appears if measurement data remains in this
instrument when attempting to connect to the AL-4000 in new patient mode.
Click the “OK” button (1) to delete the data in this instrument and connect to the
AL-4000.
Click the “Cancel” button (2) to stop communication. (Fig. 2)
3-19
(1)
(2)
(Fig. 1)
To Next Page
Loading...
Need help?
General
