Tomey UD-8000 - A-Scan Image Diagnosis Display (Only When AL-4000 Is Connected); Switching to the A-Scan Diagnosis Display

3-169 ■
3.9 A-scan image diagnosis display (only when AL-4000 is
connected)
3.9.1 Switching to the A-scan diagnosis display
Switch to the A-scan diagnosis referring to “3.2.8 Switching modes.”
1) The initial screen to allow you to check the Ref. data when switching modes
is displayed. (Fig. 1)
2) Touch the “Ref.Wave” button (3) and activate the “FREEZE” button (3) to
start measurement using the registered Ref. data. Then, touch the
“FREEZE” button (1) to start measurement.
3) Touch the “Reset” button (2) for a few seconds to delete the Ref.data. The
measurement screen appears after the Ref. data is deleted.
4) The same initial screen appears when all measurement data is cleared
(preparation for measuring a new patient).
(Refer to “3.2.6 Clear all measurement data (preparation for measuring a
new patient).”)
(Fig. 1)
(2)
(1)
3-591