■
3-132
3.6 Calculation functions in light interference (Opt) mode
Switch to the light interference (Opt) mode by referring to “3.2.8 Switching
modes.”
3.6.1 Selection of patient ID handling method
■
In the same ID use mode, the same ID is used among
all the instruments being connected. Carefully check
the patient information before entering and deleting the
information.
When this instrument is to be used in conjunction with OA-1000, the patient
ID handling method at the time of connection must be set.
Refer to “3.12.2 i) OA Connection Setup” in Utility to make the setting.
3.6.2 Capturing measurement data
When measurement data is transferred from the OA-1000 side while this
instrument is being connected with OA-1000, the measurement data is
taken into this instrument.
Refer to “3.2.1 j Connecting with the light interference axial length
measurement unit OA-1000” in this document for how to connect with
OA-1000, and to the user’s manual of OA-1000 for how to make
measurement.
To Next Page
Loading...
