■
3-24
3.2.3 Turning the power on and adjustment after turning the power on
■
To restart the system, turn the power off, wait for ten
seconds or so, and turn it on again.
a) Turning the power on
1) Turn on the power switch (1) on the side of the instrument.
(Fig. 1)
2) The startup screen (Fig. 1) appears and the B-scan diagnosis probe is
calibrated.
When both of a low frequency probe (15MHz) and a high frequency probe
(60MHz) are connected to the instrument, the first priority is given to the
calibrations of the probe used when the power was last turned off.
(1)
(Fig. 1)
3-24
3-25
To Next Page
Loading...
