Tomey UD-8000 - Selecting Specific Axial Length Data to be Used in Calculating IOL Power

3-135 ■
3.6.4 Selecting specific axial length data to be used in calculating IOL power
The average value is normally adopted for the measurement data to be
saved or used for calculating the IOL power, but specific data can also be
selected.
1) Touch the “Edit” button (1) to open the edit screen. (Fig. 2)
2) Use the “selection cursor movement” buttons (2) to move the selection
cursor (3) to the data which is to be used in calculating the IOL power. To
use the average value in IOL power calculation, move the selection cursor
(3) to the average axial length data at the bottom.
3) When the “Select” button (4) is touched, it is selected as the data to be
used in calculating the IOL power, and a “*” appears on the left of the data.
(Fig. 2)
(2)
(3)
(4)
3-96
(Fig. 1)
(1)
3-95