i-1
■
i Important Safety Information
■
Do not install this instrument in a location where explosives or inflammable
substances are used or stored. Fires or explosion may occur.
■
Do not remove the cover of the instrument. You may be directly exposed to
high voltage sections.
■
Do not disassemble or modify the instrument. You may be directly exposed to
high voltage sections.
■
Disconnect the power cord from all the connected devices before installing
and/or servicing the instrument. Otherwise, you may get an electric shock.
■
Sterilize probes and the eye cup before use.
■
Do not use probes and the eye cup with its contact section damaged.
Measurement error may occur, as well as the cornea or eyelid may be injured.
■
You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void your authority to operate the
equipment.
■
Do not place water or chemicals on the instrument. Any water or chemicals
entering the instrument may cause an electric shock or failure.
■
Do not allow water or chemicals to splash on probes, except for the tip caps.
Any water or chemicals entering the instrument may cause an electric shock
or failure.
■
Only use the specified terminal for connection of the instrument. Using
another type of terminal may result in failure of the instrument.
■
This instrument is a diagnostic/measuring device specially designed for
ophthalmology. Never use the instrument for other purposes.
■
The terminal for connecting the instrument to external devices is not isolated
from the internal circuit. Inappropriate wiring may damage the internal circuit.
Never touch any of these terminals and the patient at the same time. Be sure to
contact Tomey or our local distributor before using the external output
terminal.
■
When operating this instrument connected to other devices, only use devices
that satisfy IEC60601-1 or equivalent safety requirements, or that conform to
IEC60950 and whose power source is insulated with an isolation transformer,
in order to satisfy the relevant safety requirements for medical equipment.
■
In-house wireless stations, specified low power wireless stations, and amateur
wireless stations for wireless frequency identification also use the frequency
band used for wireless communication of this instrument. Check that none of
To Next Page
Loading...
