Chapter 2 – Implement Setup
7
2.1.2. X14 console
Creates a new implement profile for the attached implement.
Note: Existing implement files can be imported from a USB. Refer to
the Guidance and Auto Steering manual.
To create a new implement:
1. Ensure the ASC-10 ECU is connected to the CAN bus.
If the ASC-10 is not detected during implement profile creation, the
implement will not be configured for rate control.
2.
On the Setup screen, select Implement / New .
3. Use the arrows to select the implement Type and confirm.
rigid
pivoted (tow behind)
front mount
double pivoted (tow between)
A message displays stating that the console will restart once the
implement has been created.
A default name for the implement is displayed.
Note: It is highly recommended that items are named in a
thoughtful and structured way to allow easy use in future seasons.
4. To change the default name, select IMPLEMENT NAME and
enter the new name, then confirm. The console will restart and
show the implement geometry screen.
To Next Page
Loading...
