x
Table of contents
Chapter 1 – Introduction 1
1.1. Switching between setup and operation screen 2
Chapter 2 – Implement Setup 3
2.1. Setting up a new implement 3
2.1.1. X35, X30 and X25 consoles 3
2.1.2. X14 console 7
2.2. Setting the implement geometry 8
2.3. Setting up the master switch 10
Chapter 3 – Boom Setup 11
3.1. Setting up sections 11
3.2. Setting up timing 13
3.3. Setting up section switching 14
3.4. Setting up nozzles 16
Chapter 4 – Sprayer Controller Setup 19
4.1. Setting up tanks 20
4.2. Setting up product flow 21
4.3. Setting up pressure 23
4.4. Setting up pressure control 24
4.5. Setting up the control valve 25
4.5.1. Regulator valve system 25
4.5.2. Proportional valve system 27
4.6. Setting up pump control 29
4.7. Setting up speed source 30
4.8. Setting up implement audio 31
4.9. Setting up alarms 32
4.10. Enabling section control 34
Chapter 5 – Operation (X35/X30/X25) 35
5.1. Using the sprayer dashboard 36
5.2. Opening auto section control 37
5.3. Opening sprayer controller 38
5.4. Choosing/changing tanks 40
5.4.1. Tank colors 42
To Next Page
Loading...
