4.7. Setting up speed source
30
4.7. Setting up speed source
Sets the source of speed information supplied to the implement which
is used to determine the application rate required.
1.
Select Implement / Sprayer / Speed Source .
l Speed source: The speed source used to determine the required
application rate from the sprayer.
l Fallback type: Speed source used if GPS is selected and the
signal is lost.
l Wheel Factor: If Wheel Sensor is selected as the speed source,
the wheel speed calibration factor must be calculated (or entered
here if known). Refer to Wheel sensor calibration, page 49.
To Next Page
Loading...
