19
Chapter 4 – Sprayer Controller Setup
This chapter explains how to set up the Sprayer Controller. This
controls the amount of product being applied to particular sections.
This option is available if the implement and ECU setup has been
completed or if an existing implement file has been imported to the
console.
Variable Rate Control (VRC) options are only available if VRC has
been enabled in the features menu (System / Features /
Implement ). Note: Variable Rate Control is not available on
the X14 console.
Note that these settings apply to rate control. They are not visible if
the implement is set up for section control only.
Note: Always refer to the sprayer manufacturer’s manual to set
efficient and safe settings for the particular implement.
To Next Page
Loading...
