3.1. Setting up sections
12
7. To set the threshold for low speed, select Low Speed Shutoff
next to a section (or next to All), enter the threshold and confirm.
Sections will be shut off when the system is in auto control mode
and the vehicle speed drops below this speed and will turn on
when the vehicle speed exceeds this speed.
8. To set the number of nozzles for each section, select the section
under Nozzles, enter the number and confirm.
Note: It is important to set the number of nozzles attached to
each section correctly. During operation this affects the display of
flow per nozzle information and affects pressure based control.
To Next Page
Loading...
