4.5. Setting up the control valve
28
during a pulse cycle. Anything over this figure the implement
(motor, valve actuator) will not respond.
l Controller response: This sets how quickly the controller will try
to achieve the required rate. If set too high, the sprayer may pass
the target rate and take time to adjust, searching for the right
level. If set too low, the valve will take a long time to move to the
desired rate and control will be slow to respond. Find the best
setting for the equipment being used.
l PWM frequency: The frequency at which the valve is driven.
Higher quality valves respond better to high frequency PWM.
To Next Page
Loading...
