5.5. Configuring and calibrating
48
Note that manual overrides a number of automatic features and is
not recommended for operations. It should be used for stationary
testing of nozzles only. It must be changed to the correct speed
source before operating the sprayer under normal conditions.
l Manual speed display: Enables the manual speed to be entered.
This indicator changes to Wheel Sensor if that is selected as the
speed source in the Setup screen Implement / Sprayer / Speed
Source, refer to Wheel sensor calibration, page 49.
l Tank: Displays the pressure sensor, pump speed and flow meter
information for each tank.
l Pressure sensor: Shows the calibration status of the pressure
sensor. Refer to Setup screen Implement / Sprayer / Pressure.
l Valve balancing:Displays the valve balancing wizard. Balanced
valves must be enabled in the setup screen Implement / Sprayer
/ Flow. Refer to Valve balancing wizard, page 51.
l Flow meter: Displays the flow meter calibration wizard to be
used if the calibration factor for the flow meter is not known and
entered in the Setup screen Implement / Sprayer / Flow. Refer to
Flow meter calibration, page 50.
To Next Page
Loading...
