Topcon HiPer Pro - Page 86

Setup and Survey
HiPer Pro Operator’s Manual
3-16
decisions whether or not to fix ambiguities. Low, Medium,
and High correspond to the indicator's 95%, 99.5% and
99.9% states, respectively. The higher the specified
confidence level, the longer the integer ambiguity search time
6. Click the Ports tab and set the following parameters for Serial C
(Figure 3-12 on page 3-16):
• Input drop-down list – select the desired differential
correction format.
• Period (sec) – leave as is.
• Baud rate drop-down list – select a baud rate (i.e., the rate at
which differential messages will be transmitted from modem
to receiver).
• RTS/CTS – select to enable handshaking.
TIP
TIP
Use a 38400 baud rate.
Figure 3-12. Rover Configuration – Ports
7. Click Apply.
8. Click OK to close the Receiver Configuration screen.