Installing Topcon Software
P/N 7010-0935
2-5
The Net-G3A is designed to withstand harsh field
environments and can be used as a temporary or semi-
permanent Reference Station, as needed. For permanent
installations, install the Net-G3A in a more protected and
controlled environment.
• Protection against lightning and other power surges
To protect against sudden surges in electricity, installing
lightning finials, surge protectors, etc. will help shield
electronic equipment from direct or indirect lightning strikes.
Consult a certified electrician for recommendations and
installation.
Installing Topcon Software
The Topcon GPS+ CD includes the following software programs used
for configuring and maintaining the receiver. This software is also
available on the Topcon website (www.topconpositioning.com) to
registered users.
If you are installing the program(s) from the GPS+ CD, insert the CD
into the computer’s CD-ROM drive. If you are downloading the
program(s) from the website, then extract the program’s files into a
folder on the computer’s hard drive. Refer to the Topcon Link
documentation for details on installation and usage.
If you purchased the TopNET reference station software suite, then
refer to the corresponding documentation for installing and using this
software and for configuring the Net-G3A using TopNET.
• PC-CDU
ver. 7.12 or newer
• Topcon Link
ver 7.2 or newer
• FLoader
ver 1.0.07 or newer
Net-G3A_OM_Book.book Page 5 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
