Net-G3A Configuration and Setup
NET-G3A Operator’s Manual
3-26
started. The REC LED blinks each time data is saved to the
memory.
Stopping Data Logging
Stop logging data when you need to move the receiver, download
data, or perform maintenance functions.
1. Press and hold the FN key until the REC LED light goes out.
2. To turn off the receiver, press and hold the power key until all
lights go out, and then release.
Static Surveying for Reference
Stations
Static surveying is the classic survey method, well suited for all kinds
of base station surveys. One receiver over a survey marker collects
raw data during a certain period of time. The length of the observation
sessions can vary from a few minutes to several hours. The optimal
observation session length depends on the surveyor’s experience as
well as the following factors:
• the number of satellites in view
• the satellite geometry (DOP)
• the antenna’s location
• the ionospheric activity level
• the types of receivers used
• the accuracy requirements
• the baseline length
Use PC-CDU to configure data logging. See
“MINTER Description and Configuration” on
page 3-9 or refer to the PC-CDU Reference
Manual.
Net-G3A_OM_Book.book Page 26 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
