Pre-setup Preparation
NET-G3A Operator’s Manual
2-10
Formatting the UMS Device
The NET-G3A requires an external UMS device formatted for the
FAT32 file system. The UMS device can be formatted using the
internal Disk Management application provided by Microsoft
Windows; however, this application cannot create partitions larger
than 32 GB. For more information about FAT32 limitations and how
to format the UMS device to the FAT32 file system using the Disk
Management application, refer to Microsoft® Help and Support at
www.support.microsoft.com. If you want more than 32 GB of disk
space on the UMS device, then use external disk-partition software.
Connecting and Activating the UMS
Device
1. Connect the adapter cable to the Ethernet/USB port on the rear
panel of the Net-G3A receiver.
Figure 2-4. Connecting the UMS Device
2. Connect the UMS device to the type A USB port on the adapter
cable. (See Figure 2-4). The receiver does not have to be turned
Formatting the UMS device permanently erases all
data on the device. Back up any data that you want
to keep before formatting the device.
USB flash device
USB hard device
Net-G3A_OM_Book.book Page 10 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
