Downloading Data Files from an Installed Memory Card
P/N 7010-0935
4-1
Receiver and File
Maintenance
If you are post-processing the data after completing a survey, then
download the data from the receiver’s memory to a computer.
Downloading and deleting files also creates space in the receiver’s
memory for the next survey. Occasionally, the receiver’s NVRAM
may need to be cleared to eliminate communication or tracking
problems.
As project expectations expand, the receiver’s OAF may need to be
updated to provide expanded operation and functionality. The GPS
board inside the receiver requires firmware to properly operate and
provide appropriate functionality. As Topcon releases firmware
updates, loading these updates into the receiver will ensure that the
receiver operates at its full potential.
Downloading Data Files from
an Installed Memory Card
After completing a survey, download data files from the memory card
installed in the receiver to a computer or a UMS device for storage,
post-processing, or backup. Also, the memory card holds a finite
amount of files and information, so downloading data prevents files
from being lost. The following steps use PC-CDU to download files,
but any Topcon receiver management software can be used.
Net-G3A_OM_Book.book Page 1 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
