Installing Topcon Software
P/N 7010-0935
2-7
To uninstall PC-CDU, navigate to the location of the *.exe file.
Select the file, and press Delete.
Installing FLoader
FLoader is a firmware loading program for the GPS board inside the
receiver. FLoader is available for free on the TPS website
(www.topconpositioning.com) or the GPS+ CD.
Computer requirements for FLoader are: Windows® 98 or newer and
an RS-232C port. Use FLoader version 1.0.07 or newer to correctly
configure the receiver.
1. Create an FLoader folder on your computer’s hard drive, and
place the compressed FLoader zip file (retrieved from either the
website or the GPS+ CD) in this folder.
2. Navigate to the FLoader folder, and double-click the FLoader
zip file.
3. Extract the FLoader.exe file to the FLoader folder (Figure 2-2).
4. Create a shortcut on the computer’s desktop for quick access to
FLoader (Figure 2-2).
Figure 2-2. Extract Program and Create Shortcut
To uninstall FLoader, navigate to the location of the *.exe file.
Select the file, and press Delete.
Net-G3A_OM_Book.book Page 7 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
