Topcon Paver System 5 User Manual

Maintenance
Topcon Paver System Five Operator’s Manual
8-2
3. Do not use high pressure spray water steam cleaner hoses
directly on cables and components. The components can be
used in the rain or light spraying.
4. Check the Sonic Tracker II™ Transducer daily to make sure the
Filter Foam and Transducer are clean and free of debris. If the
Filter Foam is clogged with dirt, replace it. If the Transducer
appears to be covered with debris and performance is being
affected (see Sonic Tracker II™ in Chapter 2: Operation) clean
or replace Sonic Tracker II™ Transducer using the steps listed
later in this chapter.
Sonic Tracker II Transducer Cleaning
NOTICE
NOTICE
This procedure is not meant to be a regular
maintenance procedure. Clean the Transducer
only when contamination is suspected or
evident.
NOTICE
NOTICE
Cleaning the transducer too much will result in a
shortened Transducer life and/or water damage
to the Sonic Tracker.
1. Hold the Sonic Tracker II™ in an upright position to prevent
moisture from inadvertently entering the Sonic Tracker.
2. Mix a mild detergent with water and place the mixture in a
spray bottle (use Simple Green® where available).
3. With the Sonic Tracker upright, thoroughly spray the
Transducer with the detergent solution.

Topcon Paver System 5 Specifications

General

Brand	Topcon
Model	Paver System 5
Category	Control Systems
Language	English