Toptech MultiLoad II - Page 121

Chapter 7 – Register Operations
12
1
Modbus: Read/Write Register=298, Len=1, 16-Bit Integer (rrrrr)
Modbus: Read/Write Register=299, Len=1, 16-Bit Integer (ppppp)
Modbus: Read/Write Register=300, Len=1, 16-Bit Integer (lllll)
If type -= SAMPLER_RT, rrrrrppppplllll
Where:
rrrrr – Sampler Real Time Parameter Type as
custom_logic_sampler_real_time_prompt[]
{
(“Clearing Errors”), // 00000
(“Clear Batch"}, // 00001
(“Alarm Out"}, // 00002
("Authorized"}, // 00003
{"Permissive"}, // 00004
{"Permissive Out"}, // 00005
{"Gross Delivered"}, // 00006
{"Pacing Rate"}, // 00007
{"Curr Target"}, // 00008
{"Sampler State"}, // 00009
};
ppppp – Zero-based preset number (00000-00011).
lllll = Zero based sampler number (00000-00015).
Modbus: Read/Write Register=298, Len=1, 16-Bit Integer (rrrrr)
Modbus: Read/Write Register=299, Len=1, 16-Bit Integer (ppppp)
Modbus: Read/Write Register=300, Len=1, 16-Bit Integer (lllll)
If type -= TANK_RT, rrrrrppppplllll
Where:
rrrrr – Tank Real Time Parameter Type as
custom_logic_tank_real_time_prompt[]
{
(“High High Level”), // 00000
(“High Level"}, // 00001
(“Low Level"}, // 00002
("Low Low Level"} // 00003
{"Bypass Alarm"}, // 00004
{"Active"}, // 00005
{"Alarm Out"} , // 00006
{"Close Tk Valve"}, // 00007
{"Status Tk Valve"}, // 00008
{"Open Tk Valve"}, // 00009
{"Start Trigger Level"}, // 00010
{"Stop Trigger Level"}, // 00011
};