Toptech MultiLoad II - Page 33

Chapter 6 – Meter Commands
33
Query 0 and 1 Responses:
wwww= preset state in hexadecimal as:
enum
{
PRESET_IDLE = 0,
PRESET_LOW_FLOW = 1,
PRESET_HIGH_FLOW = 2,
PRESET_1ST_TRIP = 3,
PRESET_2ND_TRIP = 4,
PRESET_FINAL_TRIP = 5,
PRESET_START = 6,
PRESET_ALARM = 7,
PRE SET_COMPLETE = 8,
PRE SET_NOT_AUTH = 9,
PRESET_WAIT_TMS = 10,
PRESET_AUTH = 11,
PRESET_PRESET = 12,
PRESET_DISABLED = 13,
PRESET_STOP = 14,
PRESET_REMOTE_MSG = 15,
PRESET_END_OF_BATCH = 16,
PRESET_ARCHIVING = 17,
PRESET_CLEARING = 18,
PRESET_TRANS_DONE = 19,
PRESET_DIVERT = 20,
PRESET_NO_STATE = 99
} preset_state;