Toptech MultiLoad II - Page 34

Chapter 6 – Meter Commands
34
xxxx= preset status #0 in hexadecimal as:
union
{
unsigned int value;
struct
{
unsigned char preset_enabled:1; // preset is enabled
unsigned char preset_host_enabled:1; // preset enabled by host
unsigned char authorized:1; // preset available for use
unsigned char flow_active:1; // flow state is not idle
unsigned char batch_authorized:1; // product & preset has been authorized
unsigned char remote_msg:1; // remote message active
unsigned char remote_desc:1; // remote descriptive message active
unsigned char load_complete:1; // no further loading on batch can be done
unsigned char end_batch:1; // MBE command processing started
unsigned char end_batch_done:1; // MBE command processing done
unsigned char tms_got_data:1; // MEB command received
unsigned char archived:1; // batch data has been archived into
transaction database
unsigned char batch_cleared:1; // batch has been cleared
unsigned char clearing_load:1; // load clear has been issued
unsigned char load_cleared:1; // load has been cleared
unsigned char trans_done:1; // transaction is done
} flags:
} preset_status_0;