Toptech MultiLoad II - Page 64

Chapter 6 – Meter Commands
64
xxxx= sampler_status #0 in hexadecimal as:
union
{
unsigned int value;
struct
{
unsigned char program_clear_errors:1; // command to clear errors
unsigned char remote_clear_errors:1; // command to clear errors
unsigned char driver_clear_errors:1; // command to clear errors
unsigned char clearing_errors:1;
unsigned char wm_clear_errors:1; // command to clear errors
unsigned char clear_batch:1;
unsigned char unused0_6:1;
unsigned char unused0_7:1;
unsigned char unused0_8:1;
unsigned char unused0_9:1;
unsigned char unused0_10:1;
unsigned hi_limit:1; // sampler high limit input
unsigned char alarm_out:1;
unsigned char authorized:1;
unsigned char permissive:1;
unsigned char permissive_out:1;
} flags:
} sampler_status_0;