Greensmaster 3250--D
DPA Cutting Units
Page 7 -- 22
6. Install shoulder bolts (item 4) and flange nuts (item
5) to secure the LH side plates to the crossmember.
Torque the shoulder bolts from 210 to 240 in--lb (24 to
27 N--m).
NOTE: The reel nut on the left end of the cutting reel
hasablackfinishandhasLHthreads.Theleftendofthe
cuttingreelshaftisidentifiedwithagroovethatisjustin-
side of the reel spider (Fig. 22).
7. Ifreelnutswereloosenedduringcuttingreelservice,
put a block of wood between the cutting reel blades to
prevent the reel from rotating. Torque reel nuts from 90
to 110 ft--lb (123 to 149 N--m) (Fig. 22).
8. Thoroughly fill spline area of reel nuts with grease.
9. Secure the bedbar assembly to LH side plate (see
BedbarInstallationin this section). Makesurethatplas-
tic and steel washers are properly positioned.
10.Secure front and rear rollers to LH side plate (see
Front Roller Installation and Rear Roller Installation in
this section).
11.Adjust cutting unit (see Cutting Unit Operator’s
Manual).
NOTE: The parallelpositionoftherearrollertothecut-
ting reel is controlled by the precision machined cross-
memberand sideplatesof thecuttingunit.Ifnecessary,
the cutting unit side plates can be loosened and a slight
adjustment can be made to parallel the rear roller with
the cutting reel (see Leveling Rear Roller in the Set--U p
and Adjustments section of this Chapter).
12.Install new O--ring ( item 12) on weight (item 10). Se-
cure weight to side plate with two (2) cap screws and
nuts.
13.If cutting unit is equipped with optional groomer or
rearrollerbrush,installcomponentsforthoseoptionsto
cuttingunit.SeeServiceandRepairssectionofChapter
8 -- Groomerforinformationongroomer.SeeRearRoll-
er Brush in this section for information on rear roller
brush.
14.Install cutting unit to the machine.
To Next Page
Loading...
Need help?
General
