To Next Page
A
Alicia EvansSep 3, 2025
What to do if Toro Paint Sprayer does not drive?
- SScott McdonaldSep 3, 2025
Close the bypass valve.
What to do if Toro Paint Sprayer does not drive?
Close the bypass valve.
What to do if my Toro 34215 Paint Sprayer engine will not start?
If the engine will not start, starts hard, or fails to keep running, consider the following: * Ensure the fuel tank is filled with fuel. * Open the fuel shutoff valve. * Position the throttle control midway between the Slow and Fast positions. Set the choke to the On position when starting a cold engine, or to the Off position when starting a warm engine. * Clean or replace the fuel strainer located at the bottom of the fuel tank. * Clean the foam filter element or replace the paper filter element. * Check the spark plug wire connection at the spark plug, and clean, adjust, or replace the spark plug if faulty. * Check electrical connections for good contact; clean connector terminals with electrical-contact cleaner and apply dielectric grease before reconnecting.
What to do if the Toro 34215 Paint Sprayer starter does not rotate the engine?
If the starter does not rotate the engine: * Ensure the park brake is set. * Check electrical connections for good contact, clean connector terminals with electrical-contact cleaner, apply dielectric grease, and connect the connectors. * Replace any blown fuses.
Why does my Toro 34215 Paint Sprayer engine overheat?
The engine may overheat due to: * Excessive engine load; reduce the machine's ground speed. * Low oil level; add oil to the proper oil level. * Cooling fins and air passages plugged with dirt or debris; clean them.
General| Type | Airless |
|---|---|
| Max Pressure | 3000 PSI |
| Hose Length | 25 ft |
| Nozzle Size | 0.015 in |
| Power Source | Electric |
| Spray Pattern | Adjustable |
| Nozzle Type | Reversible |
Follow these safety guidelines to prevent injury during operation.
Ensure operators are trained before using the equipment.
Safety precautions for everyday use of the machine.
Use caution and specific techniques when operating on slopes.
Ensure tires are inflated to the correct pressure.
Verify engine oil is at the proper level before use.
Step-by-step guide to connect the machine's battery.
Identification and function of primary operating controls.
Temporarily stop or deflect granular material discharge.
Instructions for using the spray wand and its trigger lock.
Procedure to verify and maintain the engine oil level.
How to adjust the operator platform's position.
Steps to move the machine forward safely.
Adjusting the spreader for accurate material distribution.
How to load material into the spreader hopper.
Determine the machine's speed for calibration.
Procedures for adding liquid chemicals to the spray tank.
Safe methods for loading onto trailers or trucks.
Overview of maintenance tasks and their intervals.
Guide to greasing key points on the machine.
Cleaning or replacing air cleaner elements.
Procedure for draining and refilling engine oil.
How to access and remove the spark plug.
Procedure to clean the fuel sediment cup.
Steps to remove the spark arrester for servicing.
Cleaning and maintaining the machine's battery.
How to test and charge the battery.
Steps to safely remove the battery.
Ensure proper tire inflation.
Fine-tuning the spreader pattern control.
Inspect hoses, nozzles, and strainers for damage.
Removing debris to prevent overheating.
Proper methods for disposing of chemicals.
Steps to prepare for long-term storage.
Specific steps to prepare the sprayer for winter.
