Toro Reelmaster 5100-D - Page 130

7. Lay transmission on its side and remove motor cylin-
der block assembly from the housing. Remove pump
cylinder block assembly from pump shaft (Fig. 46).
Figure 46
8. Remove the slipper guide and piston assemblies from
cylinder blocks (Fig. 47).
NOTE: Pump and motor cylinder block assemblies are
identical. To avoid mixing wear patterns, do not mix parts
between pump and motor cylinder block assemblies.
Figure 47
9. Use an o-ring pick or wire to remove thrust plates from
swashplate and housing (Fig. 48).
Figure 48
10. Use an internal hex wrench to remove pipe plug over
motor shaft bearing retaining pin (Fig. 49).
Figure 49
Transmission Repairs Page 4 - 46 Reelmaster
®
5100-D