Assembly of Alternator
1. Reverse steps 1 - 8 under Disassembly and Inspe
c-
tion and also following the following instructions:
2. The rear bearing has an eccentric groove. Install the
snap ring so its projection fits in the deepest part of the
groove.
3. When install
ing a new rear bearing, press fit the
bearing with its groove facing the slip ring side.
4. Heat the rear bracket when press fitting the rear
bearing into the bracket.
Figure 58
IMPORTANT: Put a wire through t
he small hole in the
rear bracket to lift the brushes before installing the
rotor to the rear bracket (Fig. 58). Remove the wire
after the rotor is installed.
Repairs Page 5 - 44 Reelmaster
®
5100-D
To Next Page
Loading...
