8. To remove the side gears and pinion mate gears,
rotate the side gears. This will allow the pinion mate
gears to turn to the opening of the case (Fig. 26).
Remove the pinion mate gears and the spherical
washers behind the gears.
Figure 26
9. Remove the eight side cover capscrews. Remove the
the side cover from the carrier assembly (Fig. 27). Clean
the gasket material from the mating surfaces before
reassembly.
Figure 27
10. If unit has an expansion plug, remove it by driving a
pointed punch through the plug about 3/8 inch (10 mm)
from the outer edge. When the hole is large enough,
insert a large screwdriver through it and pry the plug
outward (Fig. 28).
Figure 28
Reelmaster
®
5100-D Page 6 - 11 Repairs
To Next Page
Loading...
