Toro Reelmaster 5100-D - Page 218

11. Before pressing pinion out of housing:
If unit was equipped with an expansion plug
(removed in step 10), remove the snap ring and shim
from the end of the pinion (Fig. 29).
If unit is equipped with a pinion coupler for 4WD (no
expansion plug), nut, pinion spacer and pinion
coupler (Fig. 3) must be removed before pressing
pinion out of housing.
12. Position the housing assembly on a suitable press.
P
lace a 1/8 inch (3 mm) piece of steel or a screwdriver
blade under the edge of the spur gear. This will prevent
the spur gear from cocking and possibly cracking the
housing (Fig. 30).
When the pinion is close to being pressed completely
out
of the bearing, reach under the housing and catch
the pinion in your hand to prevent any damage to the
pinion.
Figure 29
Figure 30
Removing the drive pinion releases the spur gear,
spacer, and outer pinion bearing for removal (Fig. 31).
If unit was equipped with a pinion coupler for 4WD (no
expansion plug), remove oil seal from housing (Fig. 3).
Figure 31
Repairs Page 6 - 12 Reelmaster
®
5100-D