Toro Reelmaster 5100-D - Page 282

46. Apply a small amount of clean multi-purpose grease
on the lip of the seal. Install the seal onto the jacket tube
and input shaft (Fig. 111).
47. Make a final inspection of the r
elative groove posi-
tions on the side of the unit (Fig. 24). Components of the
steering valve with alignment grooves, must be assem-
bled so that their alignment grooves are positioned as
illustrated for the valve to function correctly (Fig. 24).
Disassemble and correct the assembly if necessary.
48. Remove the four nuts holding the unit to the fixture
a
nd remove the unit (Fig. 112).
Figure 111
Figure 112
Repairs Page 7 - 52 Reelmaster
®
223-D/5100-D/5300-D